Airius System 35 Installationsanleitung PDF herunterladen (Seite 16)

Suspended Ceiling Kit Assembly & Installation

Remove the Air Pear from its box and plastic

protective bag. The bail (handle) is attached via

two Torx screws. Loosen these screws and

remove the bail (discard at your discretion).

Remove all components from packing materials.

Using the box that the suspended ceiling kit unit

arrived in, open end up, place the 2’ x 2’ flat air

intake grille, over the open end of the box, face

down. The right angle corner tabs should be

facing up. Insert the Air Pear unit (with bail

removed) into the center hole so that the nozzle

extends below the air intake grille and the cord is

hanging over the edge.

(1) Dome

(1) J-box and (1) Faceplate

(1) 120V, 230V or 277V Receptacle, (2) Thumb Screws*

(1) Air Intake Grille

Right Angle Tabs

*Included in hardware bag

2 ft cord with

plug attached

(4) Phillips Screws*

Cutout for Power Cord/Receptacle

J-box Mounting Location

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22 23 24

Keine Kommentare

Airius System 35 Installationsanleitung Seite 16