Airius System 35 Installationsanleitung PDF herunterladen (Seite 17)

Suspended Ceiling Kit Assembly & Installation (cont.)

Place dome over Air Pear unit and align it with

screw holes. Note that cutout should face the

j-box mounting location. Dome should seat into

the rim designed for it on the base, if necessary

gently push the dome edge in until it seats

inboard of the rim.

Insert the four Phillips screws (10-32 x 5/8”

provided) through ears in dome and into threaded

brass inserts. Screws will go in easily when

aligned properly. Do not overtighten, as galling or

stripping could occur.

When dome is installed, the power cord needs to

be fed through the cutout in the dome.

Have an electrician or similarly qualified person

wire, with MC-type cable, the supplied receptacle

into the j-box in close proximity to the intended

installation location. Fasten the supplied metal

faceplate to the j-box. Follow all local and

National Electric Codes. MC cable should have

enough length to ensure easy installation.

Place the assembled suspended ceiling kit into

the T-bar grid. The air intake grille is designed to

replace a 2’ x 2’ ceiling tile. If replacing a 2’ x 4’

tile, please use an additional piece of 2 ft. T-bar

suspension material to finish the edge and

provide additional strength and rigidity to the

existing suspension system.

Note cord position

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24

Keine Kommentare

Airius System 35 Installationsanleitung Seite 17